Dixon 4500 Series User Manual download pdf (Page 34)

CARE AND MAINTENANCE

NEUTRAL ADJUSTMENT

DRIVE MACHINE UNTIL HYDROSTATS HAVE WARMED UP. WITH ENGINE

RUNNING AND THE PARKING BRAKE OFF, SWING OUT THE CONTROL

LEVERS. IF MACHINE STARTS TO CREEP, FOLLOW THE INSTRUCTIONS

BELOW.

1. Stop the engine, engage parking brake and raise rear

of frame with jack or blocks so that rear tires do not

contact the ground.

2. Swing out the control levers, start the engine and release

the parking brake.

3. Raise the seat to access hydro control linkage. If right

wheel creeps, adjust right side linkage and vice-versa.

Use procedure below.

a. Loosen, but do not remove, the bolt in the

control tube P/N 5540.

b. Loosen jam nuts on ends of the coupler P/N

7736.

c. If right wheel is creeping forward, turn coupler

counter-clockwise until neutral is achieved

(clockwise for left side). If right wheel is creeping

backward, turn coupler clockwise until neutral

is achieved (counter-clockwise for left side).

d. Tighten jam nuts against coupler.

e. Tighten bolt in control tube.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

No comments

Dixon 4500 Series User Manual Page 34