Dixon ZTR RAM 50 User Manual download pdf (Page 37)

CARE AND MAINTENANCE

MOWER DECK LEVELING PROCEDURE:

1. Place mower on a smooth, level surface and check

tire pressures to insure correct stance. Tires

should be inflated as follows.

Front: 16 - 21 lbs

Rear: 8 - 14 lbs

2. Turn each outer blade tip to align with the deck

in a side to side manner.

3. Measure from the floor surface up to the bottom of

the blade tip on the discharge side of the mower.

Retain this measurement. Move to the opposite

side and check to see if that measurement is the

same.

If adjustment is required, turn nut on one or

both of the front L-rods until both measurements

are equal.

4. Turn each outer blade tip to align with the deck in a

front to rear manner.

5. Measure from the floor surface up to the bottom of

the blade tips at

both the front and rear of the

blades.

Rear of blade tips should be 1/8" to 1/4"

higher than the front of blade tips. If adjustment is

necessary, loosen jam nuts on tie bar. Rotate bar

to achieve desired height. Retighten jam nuts.

(See Illustration B, page 36)

NOTE: This will place the mower deck in a base

measurement position. Additional adjustment

may be required to achieve desired cut for the

type of grass or conditions involved.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

No comments

Dixon ZTR RAM 50 User Manual Page 37