Dixon D26KH48 Operator's Manual download pdf (Page 5)

UNASSEMBLED PARTS

Battery

(1) Quick

Connect

Key(s)

Slope SheetKeys

(1) Oil Drain Tube

(2) Nut Keps (2) Hex Bolts

*Installed by Dealer

*Brush Guard Kit

TO CHECK BATTERY (See Fig. 1)

• Lift hood to raised position.

Fig. 1

LABEL

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard

wrench sizes are listed.

(1) 1/2" wrench Tire pressure gauge

(2) 7/16" wrenches Utility knife Pliers

When right or left hand is mentioned in this man ual, it means

when you are in the operating po si tion (seated be hind the

steer ing wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton .

• Cut along dotted lines on all four panels of carton.

Remove end panels and lay side panels flat.

• Check for any additional loose parts or cartons and

remove.

BEFORE REMOVING TRACTOR FROM

SKID

NOTE: If this battery is put into service after month and

year indicated on label (label is located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in Maintenance section of this manual

for charging instructions).

• For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments"

section in this manual.

ADJUST SEAT (See Fig. 2)

• Sit in seat.

• Lift up adjustment lever (A) and slide seat until a com-

fortable position is reached which allows you to press

clutch/brake pedal all the way down.

• Release lever to lock seat in position.

Fig. 2

NOTE: You may now roll your tractor off the skid. Follow

the instructions below to remove the tractor from the skid.

1 2 3 4 5 6 7 8 9 10 ... 29 30

Comments to this Manuals

No comments

Dixon D26KH48 Operator's Manual Page 5

Comments to this Manuals

Related products and manuals for Tractor Dixon D26KH48