Dixon ZTR 5020 Operator's Manual download pdf (Page 31)

CARE AND MAINTENANCE

CHANGING THE ENGINE OIL:

1. The "snap lock" oil drain valve is located on the left side of the engine crankcase.

2. Place a suitable container under the drain valve. The fitting of a short piece of

hose to the valve will help direct the oil.

3. Push the valve body in and twist to clear the detent notch.

4. Pulling the valve body outward will start the flow of oil.

NOTE: Refer to engine manufacturers recommendations for frequency of oil changes.

HOT oil may cause burns. Allow engine to cool before draining oil.

OIL FILL: 1. Push the valve body in and twist into the detent notch.

2. Clean any spilled oil from engine and chassis.

3. Refill engine with type, and quantity of oil recommended by the engine

manufacturer in engine literature.

NOTE: Engine oil changes on the Estate Series Models will require replacement of the

oil filter. These filters can be obtained from any authorized Kohler engine

dealer.

PROTECT YOUR INVESTMENT:

The use of non-original oil or air filters may result in damage to the engine and a loss

of warranty. Listed on page 39 are the correct Briggs & Stratton part numbers for

each engine in the Estate Series.

PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS -

PROTECT YOUR ENVIRONMENT-

Page 29

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

No comments

Dixon ZTR 5020 Operator's Manual Page 31