Dixon ZTR 5421 Operator's Manual download pdf (Page 41)

CARE AND MAINTENANCE

MODELS ZTR 5501 & ZTR 5601 DRIVE SYSTEM ADJUSTMENTS

FORWARD TRAVEL SPEED ADJUSTMENTS:

Stop engine, move levers to drive position, lightly push each upper control lever forward

until a resistance is felt on the lever.

At this time, check that the forward lever stops on the bottom of each lever are hitting the

stop blocks.

If adjustment is required, loosen the lock nuts on the lever stop and turn the bolt in until the

lever hits the stop block before resistance is felt in the hydrostat.

NOTE:

Balance of travel speed. If mower tends to pull to either side, re-adjust lever

stop on fast side to slow the hydrostat down and even out the ground speed.

DO NOT SPEED UP THE SLOW SIDE, AS OVER STROKING OF THE

HYDROSTAT COULD RESULT IN DAMAGE TO THE UNIT.

If upper control levers are slightly offset following this adjustment, they can be

realigned by bending them slightly.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 69 70

No comments

Dixon ZTR 5421 Operator's Manual Page 41