Dixon ZTR 5424 Operator's Manual download pdf (Page 28)

OPERATION

28-Husqvarna

Weak Battery

If “jumper cables” are used for emergency starting,

follow this procedure:

Jumper Cables

Connect each end of the RED cable to the •

POSITIVE (+) terminal on each battery, taking care

not to short against chassis.

Connect one end of the BLACK cable to the •

NEGATIVE (-) terminal of the fully charged battery.

Connect the other end of the BLACK cable to a •

good CHASSIS GROUND on the mower with the

discharged battery, away from the fuel tank and

battery.

To remove cables, reverse order

Remove BLACK cable rst from chassis and then •

from the fully charged battery.

Remove RED cable last from both batteries.•

8011-642

Jumper cable connection

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt

negative grounded system. The other vehicle

must also be a 12-volt negative grounded

system. Do not use your mower to start other

vehicles.

WARNING!

Lead-acid batteries generate

explosive gases. Keep sparks, ame

and smoking materials away from

batteries. Always wear eye protection

when around batteries.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 72 73

No comments

Dixon ZTR 5424 Operator's Manual Page 28